公司新聞
攤鋪機的維修保養和常見故障的排除
來源:http://guixin.net.cn/ 日期:2022-08-24
隨著路面施工技術的不斷完善和質量要求的不斷提高,瀝青混凝土攤鋪機在路面施工中的應用越來越廣泛。為了能使攤鋪機更好地發揮其優越的性能,就必須對其進行保養以及問題的避免,下面濟南攤鋪機出租廠家來講講相關內容吧。
With the continuous improvement of pavement construction technology and the continuous improvement of quality requirements, asphalt concrete pavers are more and more widely used in pavement construction. In order to enable the paver to give better play to its superior performance, it is necessary to maintain it and avoid problems. Let's talk about the relevant contents from the Jinan paver rental manufacturer.
新機器的使用一定要重視磨合期的保養,不能因搶工程進度而忽視磨合期的保養,否則將會加速部分元件的異常磨損,為機器發生故障留下隱患。磨合期滿,必須進行必要的強制保養。
In the use of new machines, attention must be paid to the maintenance during the running in period. The maintenance during the running in period cannot be neglected because of the rush to the project progress. Otherwise, the abnormal wear of some components will be accelerated and hidden dangers will be left for the machine failure. When the running in period expires, necessary mandatory maintenance must be carried out.
平時使用一定要嚴格按照維修保養手冊進行及時的維修保養,機器的保養主要是潤滑,包括及時加注和更換機油、黃油、齒輪油和液壓油等。如果更換機油不及時,或使用不合格的機油,都可能導致發動機燒機油。
In normal use, timely maintenance must be carried out in strict accordance with the maintenance manual. The maintenance of the machine is mainly lubrication, including timely filling and replacement of oil, butter, gear oil and hydraulic oil. If the engine oil is not replaced in time or unqualified engine oil is used, the engine may burn out.
另外,及時清理或更換空氣濾芯,啟動及熄火時均怠速運轉3min~5mm,使用合格的柴油,都是避免該機燒機油的必要措施。對于關鍵潤滑點采用自動潤滑的系統,當氣溫低于20℃左右時,應使用2號潤滑脂。
In addition, it is necessary to clean or replace the air filter element in time, run at idle speed for 3min ~ 5mm during startup and shutdown, and use qualified diesel oil to avoid burning the engine oil. For the system with automatic lubrication for key lubrication points, when the temperature is below 20 ℃, No. 2 grease shall be used.
自動潤滑泵和遞進式分配器內有柱塞副,配合非常精密,所以對黃油的清潔度要求很高,不能有任何固體雜質。否則會造成潤滑泵柱塞磨損、單向閥卡滯、柱塞彎曲、電機燒毀、分配器卡死等故障。如果自動潤滑點的備用黃油嘴漏油,應找一個反向密封性好的換上。只有在攤鋪瀝青料時才有必要使用高溫潤滑脂。
There are plunger pairs in the automatic lubrication pump and the progressive distributor, and the matching is very precise, so the cleanliness of the butter is very high, and there should be no solid impurities. Otherwise, the lubrication pump plunger will be worn, the one-way valve will be stuck, the plunger will be bent, the motor will be burnt, and the distributor will be stuck. If the spare grease nipple of the automatic lubrication point leaks oil, replace it with one with good reverse sealing. It is only necessary to use high-temperature grease when paving asphalt.
刮板輸料鏈的潤滑刮板輸料鏈和料接觸,工作環境惡劣,如果得不到潤滑,會導致銹蝕,進料粘結、打節,輸料鏈和底板磨損加速,甚輸料卡死,鏈條斷裂等。
Lubrication of the scraper conveyor chain the scraper conveyor chain is in contact with the material, and the working environment is bad. If it is not lubricated, it will lead to corrosion, binding and knot of the feed, accelerated wear of the conveyor chain and the bottom plate, and even jamming of the feed, chain fracture, etc.
刮板輸料鏈的潤滑建議采用各種廢潤滑油和柴油的混合物,柴油滲透性強,利于進入鏈條內部。潤滑前應先打開輸分料開關,將間隙內的料進行清理,然后揭開料斗前的蓋板。將混合油澆在鏈條上。每1d~3d潤滑一次,每次施工后進行。關注我們http://guixin.net.cn,了解更多!
It is recommended to use a mixture of various waste lubricating oils and diesel oil for the lubrication of the scraper conveying chain. The diesel oil has strong permeability and is easy to enter the chain. Before lubrication, turn on the feeding / distributing switch to clean the materials in the gap, and then open the cover plate in front of the hopper. Pour the mixed oil onto the chain. Lubrication shall be carried out once every 1d-3d, after each construction. Follow us http://guixin.net.cn Yes, learn more!